Various abnormalities and causes of pet bottles

A, coking: 1 bottle embryo temperature is too high 2 blower blower power is too small, wind uneven
B. Inhomogeneous thickness: The uneven output power of the corresponding heating lamp causes partial uneven heating. With pre-blowing time, pre-blowing position, pre-blowing pressure are related.
C, bottle support ring bruises: preform embryo output guide, into the embryo transfer turntable, pull guide block robot, the corresponding position of the bottle guide block normal operation
D, bottle capacity is too small (large): pre-blowing time and blowing time is too long, the mold temperature is set too low temperature bottle capacity is small, the opposite is large.

E, the bottle has oil: no replacement after the mold replacement

F, bottle height ranging: 1 different mold manufacturing 2 mold temperature is too low, uneven bottle thickness caused by bottle shrinkage when the bottle is sterilized too

G. Small dents in the bottle are not smooth: There are substances inside the mold.

H, bottle white: bottle heating temperature is too low, local: the corresponding heating lamp output power is too small, all: the preform temperature is set too low

I. Bottle neck concave eccentricity: 1 Out of the bottle conveying carousel is in the wrong position 2 The guide block of the bottle is uneven and the clearance is too small 3 The conveying wind is too small, the bottle conveying is not smooth and it is conveyed by the transfer carousel.
J. There is a small amount of material in the neck of the bottle: there is condensate inside the mold.

Plastic Playhouse

Kids Plastic Playhouse, Plastic Outdoor Playhouse, Cheap Plastic Playhouse, Childrens Plastic Playhouse

Liben Group Corporation , https://www.trampolinearea.com