1. The floor on which the dance floor glue is installed must meet the construction requirements. Under normal circumstances, the original ground on which the dance floor rubber is installed will not be sanded, and it will be powdered. The ground is relatively flat and there is no big difference in the drop (the error should be within 2mm). If the flatness of the ground is not enough, a layer of cement shall be self-leveling on the original floor where the dance floor rubber is installed, and the cement floor may be completely dry before the dance floor rubber can be laid.
2. The dance floor is glued and unloaded, and it is considered to be a good area before the installation of the dance floor glue (consumables are about 5% in the case of a regular venue). Open the dance floor glue security room according to the size of the good cut size, length and width are 5CM.
3. Adhere to the dance floor adhesive tape, use one side of the tape to stick to the original floor of the seam where the dance floor glue is located, and stick it to the back of the dance floor to ensure that the dance floor is glued to the original ground. tight. Under special circumstances, some or all of the glue is used for bonding.
4. The dance classroom is glue-welded, and the slot machine is used to slot the gap between the dance floor and the glue. Then the dance floor is glued and welded with a welding torch.
5. Finally, according to the size of the venue, the extra dance floor rubber should be cut off with a professional construction knife and cleaned.