Female watch strap long how to do Female watch long strap shorter

Contrast female watch chain direction. Prepare to dismantle the strap before you carefully see clearly the arrow on the back of the strap, the arrow down the general female bracelet is under the big small, the strap into the slot of the meter, according to the arrow, align the female bracelet The direction of the button hole Confucius.

Remove the nail. Loosen the bezel handle, place the strap in the watch's face, and hold the bezel of the bezel to the pinhole of the strap, gently tighten it, and the pin connecting the strap will be ejected. If the strap is longer, it is recommended to remove the same number of sections on both sides of the bracelet to ensure balance when wearing women's watch .

Reload the table nail. The strap removed to the appropriate size of the wrist, the first disconnect the two straps together, did not go in and then press the second step of the method to the top of the needle or a hammer percussion can! (Note: When reassembling the strap, you should insert the steel needle is best in the opposite direction of the arrow, and is an advanced choice of needle day, it will be easier to load).

When removing the metal strap in the strap section, it is best to double the number, and must be around the buckle evenly unloaded. In order to ensure that the cliche is the center, wearing only comfortable, especially the thinner wrist, when going to the bracelet more pay attention to this issue.

Hollow strap strap and section of the bolt, the general use of the so-called "hairpin." More easily loose and sprang, but the solid core strap generally wear nail or screw to connect the strap section, a long time may also be loose and flee, so be sure to regularly check. You can use needle-shaped things to force it pushed out, if a bolt pushed out, it is already loose. If you find signs of exposure, go to repair immediately. Some women in particular love this question out of the table, it is recommended that you every 7-8 years to replace the case with a bolt, that thing is very cheap. With the best bolt screwed when touch the adhesive, in order to ensure its solid.

Disassembly strap section is a direction, usually in the strap is an arrow to indicate the direction of the pin between the strap section punch out, can not be reversed, the installation direction and take the opposite direction.

Like a leather strap, rubber strap is easy to damage, a few years will have to change. In addition to the time should pay attention to the size of the strap should also consider the color, especially the women 's fashion watch . Dial is white, the strap can be blue, obviously not with (should be white), including the color of the leather strap buckle should be consistent with the color of the case, only the coordination will produce beauty.

The cut (short cut) of the strap loop should always be above the female form (when the female form is looking and the crown is on the right). Strap unlike people's belts, installation orientation is specified.

Metal strap. When the female form spread out, the letter or logo on the discount disc to dial the same, if it is upside down, that is, the strap loaded anti. You can use the thumb to open the buckle on the right, butterfly buckle can only see whether the logo and the dial is a smooth. Strap back, opening and closing must not be handy.

With a discount strap, there will be a lot of holes on the side, used to adjust the strap length. When retracting the strap, also pay attention to the side of the clasp adjustment section (retract and release) that should not retract the orientation of the closing axis of the strap. This will form a lever clasp, so that the strap is very easy to open, it is easy to lose female form.

Poly fashion watch network Recommended reading:

Quartz watch is good or mechanical watch good ladies watch brand list the world's top ten watch brand watch list